VERIFIED
One word, one instruction
For F7 (F07 on some lists), Bertazzoni writes “Overheating” in the fault column and “Contact service” in the action column. No cause, no reset, no list of items to check.
Reading the word
Overheating suggests that something inside the machine became hotter than it should. The table does not say what became hot, whether the heater, the water or an electronic part. That is why this page does not name one.
Safe handling
A machine that has overheated should be treated as hot and electrically live until proven otherwise.
- Stop the cycle.
- Switch off at the plug or breaker.
- Keep the door shut for a while, and when you do open it, expect steam and hot dishes.
- Leave the machine disconnected until service has looked at it.
Next to F6 and F8
F6 (faulty heater sensor), F7 (overheating) and F8 (heater error) are separate entries in the manual’s table, each with the remedy “Contact service”, and none of the three has an owner repair. If more than one appears, say so on the call.
Companion codes
- F6: the sensor that reports temperature, listed as faulty
- F8: the heater itself reported as an error
- E3: the E-code entry for heating that was too slow, a different symptom
Questions about F7
Does F7 mean there is a fire risk? The manual does not say that. It treats overheating as a fault for service, which is reason enough to disconnect the machine.
Will F7 clear if the machine cools down? No reset or cool-down step is printed for F7, unlike the induction hob manuals, so do not rely on it.
Overheating checks: dishwasher service in San Francisco
Please call (415) 692-0756 before using a Bertazzoni dishwasher again after an F7. We service dishwashers in San Francisco.
Model compatibility: Bertazzoni reuses codes across series and model years, so F7 / F07 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
